Reset Password
If you've forgotten your password, you can enter your email address below. An email will then be sent with a link to set up a new password.
Cancel
Reset Link Sent
If the email is registered with our site, you will receive an email with instructions to reset your password. Password reset link sent to:
Check your email and enter the confirmation code:
Don't see the email?
  • Resend Confirmation Link
  • Start Over
Close
If you have any questions, please contact Customer Service
Forgot password?
Blogs > BenP508 > My Blog

Molds  

BenP508 72M
1 posts
3/6/2016 12:11 pm
Molds

The molds are for tube tips and will open the door for a line of Colon Tubes. There will be a variety of tubes which will range from a 16" Fr 34 to a 84" Fr 75 and a dual tube unit with an Fr 38 x 30" solution feed and a waste tube that is about an Fr 100. They will be available with and without bases, retention systems and electrodes. These will all be made of<b> silicone. </font></b>Should be fun!!

Become a member to create a blog